.

Wednesday, May 15, 2019

The Challenger Accident Essay Example | Topics and Well Written Essays - 500 words

The contest Accident - Essay Examplehe Challenger mishap was caused by the failure was the destruction of the seals that are intended to prevent hot gases from leaking through the control stick during the propellant go up of the rocket motor. (Presidential Commission on the Space Shuttle Challenger Accident, 1986). The damaged O-ring seals in the feel and clevis joint were found to cause the failure of the seals.The commissions investigations pointed out several contributing mechanical and morphologic breaches that lead to the failure. Among the major structural flaws was a defect in the fittings of the aft joints piquance and clevis. Original design of the aft segments or other segments of the Solid Rocket Booster has a tone that almost perfectly fits into the clevis of the other segment. This structural design is oftentimes contaminated during handling and transport such that the roundness of the segments is altered due to pressures and transport vibrations. Minor alteratio ns in the roundness of the segments would result to differences in the diameters of the tang and the clevis. These problems may result to some fitting imperfections that could form the O-rings attached within the joint more under fire(predicate) to damage.Another contributory factor to the failure of the seals was the conditions of the O-rings during launch. It was noted that during launch time, the temperature was very cold and the launch instalment even experienced problems due to lower temperature. Furthermore the SRB used in the Challenger launch harbor been used in several other missions. This practice had been used in the space program without whatever problems. For better seal performance, tests confirmed that actuating pressure must get behind the entire face up of the O-ring on the upstream side of the groove within which the O-ring sits (Presidential Commission on the Space Shuttle Challenger Accident, 1986, p. 61). Under imperfect sealing conditions discussed above a potential greater pressure is exerted on the O-ring and would make it fit

No comments:

Post a Comment